Non-Metallic Hoses (Industrial and Hydraulic)

Rubber hydraulic hose: ten ASA series, 3/16 to 4 in inner diameter, working pressure up to 50 MPa, one to six reinforcement plies.

Request technical advice

Coils of red rubber hose in the warehouse

Product Introduction

Non-metallic (rubber) hoses carry hydraulic oil in closed circuits, and also water, acids, bases and petroleum products in industry. A hose is built from three layers: an inner tube compatible with the fluid, a reinforcement (one to six steel-wire plies or one to two textile-braid plies) that carries the pressure, and a protective cover. The company catalog covers ten ASA hydraulic series from dash −3 (3/16 in) to dash −64 (4 in) and up to 50 MPa (500 bar) working pressure; dimensions, pressure, bend radius and weight of every part number are tabulated. It also explains end-fitting attachment, crimping, cut length, storage and safety.

Inner diameter
3/16 to 4 in
Working pressure
Up to 50 MPa
Burst pressure
Up to 200 MPa
Temperature
−40 to +100 °C
Reinforcement
1 to 6 plies
Series
10 ASA series
Standards
EN / SAE / ISO
Inner diameter
3/16 to 4 in
Working pressure
Up to 50 MPa
Burst pressure
Up to 200 MPa
Temperature
−40 to +100 °C
Reinforcement
1 to 6 plies
Series
10 ASA series
Standards
EN / SAE / ISO
Inner diameter
3/16 to 4 in
Working pressure
Up to 50 MPa
Burst pressure
Up to 200 MPa
Temperature
−40 to +100 °C
Reinforcement
1 to 6 plies
Series
10 ASA series
Standards
EN / SAE / ISO

Interactive maps and models

3D part blueprint

2D part blueprint